|
|
|
|
|
2, BNC @ 75 Ohms
AS-MOD2- OSCx-FP0
AS-MOD2- OSCx-FP1
AS-MOD2- OSCx-FP1
Control Interface:
Inputs:
RF Outputs:
Physical:
Dimensions:
AC Voltage:
Temperature:
Altitude:
Humidity:
AC Voltage:
Temperature:
Altitude:
Humidity:
Part Number
Part Number
A-STARS CANADA. {All Rights Reserved}
Products
Services
Home
Whats New
About Us
Contact Us
ASI/SMPTE-310 Inputs:
Ethernet Ports (TSoIP):
GPS Receiver Inputs:
External Clock Reference:
Ethernet Ports (TSoIP):
GPS Receiver Inputs:
External Clock Reference:
Dual BNC @ 75 Ohms, 13db return loss
User selectable ASI or SMTE-310
Switching, select primary or secondary
Dual RJ45 @ 1Gbit/sec, Control/Data
1 BNC, 1.575GHz (GPS), antenna not incl
Passive or Active Antenna, 0-32db gain
Ant Current = 50mA max
Ant Voltage = Off / 3Vdc / 5Vdc, selectable
1 BNC @10 MHz, 100mV-Vpp, Ac coupling
Input impedance, 50 Ohm / >1 kOhm
User selectable ASI or SMTE-310
Switching, select primary or secondary
Dual RJ45 @ 1Gbit/sec, Control/Data
1 BNC, 1.575GHz (GPS), antenna not incl
Passive or Active Antenna, 0-32db gain
Ant Current = 50mA max
Ant Voltage = Off / 3Vdc / 5Vdc, selectable
1 BNC @10 MHz, 100mV-Vpp, Ac coupling
Input impedance, 50 Ohm / >1 kOhm
Ethernet:
Remote Controls:
GigE:
AGC:
Remote Controls:
GigE:
AGC:
1 RJ45 (Front / Rear Panel)
RF Level Telem, 0-4V (Pot Adjust)
RF Mute Control (Active Low)
2 RJ45 (TSoIP Standard)
SMA Connector (Rear Panel), 1-10 VDC
RF Level Telem, 0-4V (Pot Adjust)
RF Mute Control (Active Low)
2 RJ45 (TSoIP Standard)
SMA Connector (Rear Panel), 1-10 VDC
Connector:
Return Loss:
Level Stability:
RF Monitor:
Center Freq.:
Freq. Reference:
Freq. Stability:
MER:
Harmonics:
Spectrum Polarity:
Spectrum Out of Band:
Return Loss:
Level Stability:
RF Monitor:
Center Freq.:
Freq. Reference:
Freq. Stability:
MER:
Harmonics:
Spectrum Polarity:
Spectrum Out of Band:
SMA @ 50 Ohm, -10dbm to +10 dbm level
> 16 db
+/- 0.5 db
SMA @ 50 Ohm, -23 db down from RF output
30MHz to 860MHz (1 MHz steps)
Standard Internal TCXO @ 2ppm
OCXO Option 1 - .25 ppm
OCXO Option 2 - .01 ppm
Internal ref 2ppm (standard)
Aligned to external reference
> 45 db (typically 50 db)
50 dBc (includes spurious)
Inverted or Non-Inverted (selectable)
+/- 3.58MHz @ 0dbm
+/- 4.25 MHz (shoulders) < -50db (typ -55 db)
> 16 db
+/- 0.5 db
SMA @ 50 Ohm, -23 db down from RF output
30MHz to 860MHz (1 MHz steps)
Standard Internal TCXO @ 2ppm
OCXO Option 1 - .25 ppm
OCXO Option 2 - .01 ppm
Internal ref 2ppm (standard)
Aligned to external reference
> 45 db (typically 50 db)
50 dBc (includes spurious)
Inverted or Non-Inverted (selectable)
+/- 3.58MHz @ 0dbm
+/- 4.25 MHz (shoulders) < -50db (typ -55 db)
1.75H x 19W x 17D, 7.3lbs
110/220VAC @70W
0 to 50°C (32TO 122°F)
7500 feet above sea level max
90% non- condensing
110/220VAC @70W
0 to 50°C (32TO 122°F)
7500 feet above sea level max
90% non- condensing
AS-MOD2- OSC0
AS-MOD2- OSC1
AS-MOD2- OSC2
AS-MOD2- OSC1
AS-MOD2- OSC2
Powered by ProTelevision
a) Standard 2.00 ppm
b) Fine 0.25 ppm
c) Ultra 0.01 ppm
b) Fine 0.25 ppm
c) Ultra 0.01 ppm
Oscillator Options
Front Panel Options
a) Standard Front Panel
b) LCD Front Panel
b) LCD Front Panel
A powerful ATSC modulator for any new DIGITAL transmitter
Dual T.S. inputs: ASI, TSoIP, or SMPTE310M
A powerful 4-mode adaptive precorrection
Software-based design for flexibility, can upgrade to future ATSC 3.0
VHF and UHF output frequencies (30MHz to 860 MHz in 1 Hz steps)
Supported Modulator Modes:
Dual T.S. inputs: ASI, TSoIP, or SMPTE310M
A powerful 4-mode adaptive precorrection
Software-based design for flexibility, can upgrade to future ATSC 3.0
VHF and UHF output frequencies (30MHz to 860 MHz in 1 Hz steps)
Supported Modulator Modes:
A/53 ATSC 1.0
A/153 ATSC MH (Option PT 3714)
A/110 B&A/100:2011 SFN Mode (Option PT 3714)
A/300 ATSC 3.0 ( Firmware Upgrade Reqd)
A/153 ATSC MH (Option PT 3714)
A/110 B&A/100:2011 SFN Mode (Option PT 3714)
A/300 ATSC 3.0 ( Firmware Upgrade Reqd)
Ordering Codes:
AS-MOD2 Modulator
ASTARS
RF Services