2, BNC @ 75 Ohms

Dimensions:
AC Voltage:
Temperature:
Altitude:
Humidity:

1.75”H x 19”W x 17”D, 7.3lbs
110/220VAC @70W
0 to 50°C (32TO 122°F)
7500 feet above sea level max
90% non- condensing

Powered by ProTelevision

Request Quote

A/53 ATSC 1.0
A/153 ATSC MH (Option PT 3714)
A/110 B&A/100:2011 SFN Mode (Option PT 3714)
A/300 ATSC 3.0 ( Firmware Upgrade Req’d)

• A powerful 4-mode adaptive precorrection
• VHF and UHF input frequencies (Channel 2 VHF to Channel 69 UHF)
• VHF and UHF output frequencies (30MHz to 860 MHz in 1 Hz steps)
• Modulator Transport Stream inputs: ASI or SMPTE310M
• Software-based design for flexibility, can upgrade to future ATSC 3.0

RF INPUT (OFFAIR)
  # Inputs: 1 "F" female @ 75 Ohms
  Standard: ATSC 1.0 A/53E
  Frequency: CH 2 -13, CH14-69
  Bandwidth: 6MHz
  Power Level: -20 to + 30 dBmV
  Return Loss: 12dB

ASI/SMPTE-310 INPUTS
No. of inputs: 1
Connector: BNC @ 75 Ohms
Input Mode: SMTE-310 or ASI (selectable) Redundancy: User selectable switching
                        between primary &
                        secondary source.

FRONT PANEL INDICATORS / CONTROLS
RF Channel : +100 Channel : Channel Plan : RF mode
SNR : Baud Rate : Lock LED : Unlock LED
Unit Reset: Firmware Rev : Software Rev
Chan UP/DN : RF mode : SNR : Baud Rate
ENT : QAM / VSB : Prog : Reset (RF mode+Baud Rate)

[IND]
[IND]
[IND]
[CTL]
[CTL]

Connector:
Return Loss:
Level:
Level Stability:
RF Monitor:
Center Freq.:
Freq. Reference:

Freq. Stability:

MER:
Harmonics:
Spectrum Polarity:
Spectrum Out of Band:

SMA @ 50 Ohm
> 16 db
 -10dbm to +10 dbm level, adjustable
+/- 0.5 db
SMA @ 50 Ohm, -23 db down from RF output
30MHz to 860MHz (1 MHz steps)
Standard Internal TCXO @ 2ppm

Internal ref 2ppm (standard)
Aligned to external reference
> 45 db (typically 50 db)
50 dBc (includes spurious)
Inverted or Non-Inverted (selectable)
+/- 3.58MHz @ 0dbm
+/- 4.25 MHz (shoulders) < -50db (typ -55 db)

Ethernet:

Web GUI:

1 RJ45 (Front / Rear Panel)

Standard Browser Interfaces
ReModulator monitor & control functions

The AS-TCMOD Modulator/Transceiver is a high performance and
low cost, software defined DTV modulator that you can confidently
install as a replacement for any DTV modulator or transcoder. It can
be a Transceiver that receives an off-air signal, recode & rebroadcast
on a new channel. An ASI input allows it to operate as a normal modulator

• Supported Modulator Modes:

•Special Order Options:

10 MHz External References: GPS, Ext 10 MHz, 1PPS
Transport Stream: TsoIP
Internal Precision Clock: .25ppm or .01 ppm